[Elecraft] K3: Shift behaviour

[Ken K3IU]

I can not duplicate this on #202 with the latest firmware. It stops at 
FC=0.10 even if I keep rotating the knob anti-clockwise.
73,
Ken K3IU

Alexandr Kobranov wrote:
> Hello friends,
> want to know if i missed something:
>
> - when on CW mode turning SHIFT to low-end it is going to 0.00 and 
> then jump to 2.7 and radio is "off" (no signal like I/F switched off).
> It is for BANDWIDTH 2.8kHz and the same for 0.05kHz so bandwidth 
> independent.
> On SSB mode SHIFT is going to 0.4 and stop here, no jump to 2.7.
> Latest F/W installed.
> There should be some limits based on PITCH settings and bandwith or not?
> Tried to look in wiki and nothing about this there.
>
> http://www.zerobeat.net/mediawiki/index.php/Firmware_anomalies_that_are_considered_normal 
>
>
> Maybe it is known, maybe not, maybe it is not normal, maybe yes...
> Any comments?
>
> 73!
> L. -dst-
> K3/10 #272
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>