[Elecraft] Re: losing FL5

[Stan Rife]

    Sorry Wayne, I meant to send this to the list.

    Has the method "3" been implemented for frequency calibration yet?

Stan Rife
W5EWA
Houston, TX
K2 SN 4216
K3 SN 0690



wayne burdick wrote:
> Hi Eric,
>
> This should not have happened. You may need to re-set the filter's 
> center frequency using the FL5 FRQ menu entry. Typically the 200-Hz 
> filter has an offset of around -0.90 kHz.
>
> Also make sure that FL5 BW is set to 0.20, and that you have REFCAL 
> properly calibrated against a reference signal.
>
> 73,
> Wayne
> N6KR
>
> On May 4, 2008, at 10:00 AM, Eric wrote:
>
>> Seems I lost my 200 Hz filter after the update. In config the filter 
>> is ON, everything looks OK, but al sigs are lost when FL5 kicks in 
>> when turning WIDTH.
>
> ---
>
> http://www.elecraft.com
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft   
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>