[Elecraft] K2 Backlight LED leads too short

[Ron D'Eau Claire]

See Errata G4 to the Owner's Manual, item 2. You should have gotten it with
your kit, but if not it's available on the Elecraft web site here:

http://www.elecraft.com/manual/K2_Errata_Rev_G-4.pdf

Ron AC7AC

-----Original Message-----


My K2 backlight assembly is to be mounted 1/8" above the board but the  
leads to the LED's are 1/8".  Is there a solution or special technique  
to install this that is not spelled out in the manual?

73,
Tom
KB3PNU
Wimsatt Website:
http://wimsatt.truepath.com/