[Elecraft] K2 Backlight LED leads too short

[DW Holtman]

Tom,

Here is what I did, click on K2 diffuser

http://www.heavymetalradios.com/
I think Elecraft recommends soldering it together without a mechanical 
connection. Hope this helps.

Best,
DW Holtman
WB7SSN

----- Original Message ----- 
From: <twimsatt at wimsatt.truepath.com>
To: <elecraft at mailman.qth.net>
Sent: Sunday, March 30, 2008 4:09 PM
Subject: [Elecraft] K2 Backlight LED leads too short


> My K2 backlight assembly is to be mounted 1/8" above the board but the 
> leads to the LED's are 1/8".  Is there a solution or special technique  to 
> install this that is not spelled out in the manual?
>
> 73,
> Tom
> KB3PNU
> Wimsatt Website:
> http://wimsatt.truepath.com/
>
>
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com