[Elecraft] K3 60m ERR TXG

[Dave G4AON]

Stewart

Mine works fine from 5.150 to 5.419 MHz with 95 Watts output when set to 
"100W" on the K3 and no sign of ERR TXG messages. The alignment is set 
at the factory.

On another 5 MHz issue, the spurious levels are poor and below 
specification on frequencies below the point where a relay clicks (5.250 
MHz), above that point they are OK.  There are spurious signals approx 1 
MHz either side of the main signal that are -46 dBc when the output is 
95 Watts on 5.150 MHz.
 
73 Dave, G4AON
K3/100 #80
==============
Following the recent posting of the European 60m BPF adjustments,
I decided to set mine up.

I am having difficulties getting a sufficient bandwidth for the
UK allocation which is 5405kHz to 5260kHz i.e 145kHz.
The bandwidth between ERR TXG messages is approximately 120kHz.

I think that the US allocation runs between 5405kHz and 5332kHz
i.e 73kHz, so that should not give any errors.

Has anybody else had this problem ?

73
Stewart G3RXQ