[Elecraft] K3 Configuration

[Bill W4ZV]

Ian J Maude wrote:
> 
> Can I redo the K3 config on 5W with the PA physically in place or do I 
> need to remove it?  I am no at all happy with the output power so I want 
> to go through the config again.  Like others, I find that on SSB, the 
> output does not peak at all well.
> TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I have 
> seen in other reports.
> 

You don't need to remove KPA3 for anything unless it's failed.  There's a
separate calibration for the 5W and 50W levels on page 46 in the manual, but
they don't interact since the switchpoint between the two amps is 12/13W.

73,  Bill

-- 
View this message in context: http://www.nabble.com/K3-Configuration-tp16218384p16218430.html
Sent from the Elecraft mailing list archive at Nabble.com.