[Elecraft] K3 Configuration

[Ken Wagner]

G'morning Ian:

No, you don't have to remove the KPA3. You can do gain calibration 
procedure at any time. Just set power to exactly 5.0 watts, press tune, 
do it on all bands; then set power to 50.0 watts and do the same thing.

73,
Ken K3IU

Ian J Maude wrote:
> Hi all,
> Can I redo the K3 config on 5W with the PA physically in place or do I 
> need to remove it?  I am no at all happy with the output power so I 
> want to go through the config again.  Like others, I find that on SSB, 
> the output does not peak at all well.
> TX ALC is on but my TXGN HP Pr80 is down at 20, much lower than I have 
> seen in other reports.
>
> 73 Ian
>