[Elecraft] 50MHz Transverter

[Jim's mail]

Just a curious question.  Since you are using a K3 and that radio has 6 
meter (50 MHz) coverage included, why are you trying to use an add-on 
transverter?

Jim  KD5VXH

----- Original Message ----- 
From: "Phil Theis" <phil at k3tuf.com>
To: <elecraft at mailman.qth.net>
Sent: Tuesday, March 18, 2008 9:23 PM
Subject: [Elecraft] 50MHz Transverter


> Given the following setup: K3 using transverters, with 50MHz transverter 
> set for xv1.
> When I enter a 50MHz frequency via the com port the built in 50MHz 
> receiver is selected.  I then have to band up once to get to the xv1, then 
> I can successfully band up to 144 etc.  If I enter a 144 frequency, it 
> immediately goes to xv2.
> What would it take to get a serial command to go to a frequency in 50MHz 
> range to go directly to the xv1 selection?
> thanks
> Phil K3(352)TUF
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>