[Elecraft] 50MHz Transverter

[David Ferrington, M0XDF]

I haven't built my XV144 yet, but I think this is covered in the Owner  
Manual pg 36 (Using Transverters)
-- 
When you want to test the depths of a stream, don't use both feet.
-Chinese Proverb

On 19 Mar 2008, at 02:23, Phil Theis wrote:

> Given the following setup: K3 using transverters, with 50MHz  
> transverter set for xv1.
> When I enter a 50MHz frequency via the com port the built in 50MHz  
> receiver is selected.  I then have to band up once to get to the  
> xv1, then I can successfully band up to 144 etc.  If I enter a 144  
> frequency, it immediately goes to xv2.
> What would it take to get a serial command to go to a frequency in  
> 50MHz range to go directly to the xv1 selection?
> thanks
> Phil K3(352)TUF