[Elecraft] K3 - configure RX/TX equalizer using macros

[Thomas Norff]

To all who are missing a easy way to configure the RX/TX equalizer.
Based on the available tools i would use the Macros to set the RX/TX
equalizer for different needs.

An short example (pls don't type in the comments...):

	AI0;			no response
	K31;			is needed to use the SWT command
	MN008;		or 009 to select RX / TX equalizer
	SWT53;		tab CLR => set all values to 0dB
	SWT11;		tab A/B => select first frequency
	
				11 A/B  (1) => select 50 Hz
				12 REV  (2) => select 100 Hz
				13 A>B  (3) => select 200 Hz
				24 PRE  (4) => select 400 Hz
				27 AGC  (5) => select 800 Hz
				29 XFIL (6) => select 1200 Hz
				33 NB   (7) => select 2400 Hz
				34 NR   (8) => select 3200 Hz

	UP;			to set +1 dB
	    or					up to 16 times each !!
	DN;			to set -1 dB
	MN255;		exit the menu
	K30;			back to default (optional)
	

This one will set TX-EQ to -3/-2/0/0/0/+2/+3/+3  (this is only an example...
pls don't ask why....)

AI0;K31;MN009;SWT53;SWT11;DN;DN;DN;SWT12;DN;DN;SWT29;UP;UP;SWT33;UP;UP;UP;SW
T34;UP;UP;UP;MN255;K30;
	


73 Thomas, DM7TN
K3/100 #78