[Elecraft] Power Amplifier Jumper Block

[Ron D'Eau Claire]

You can install the KPAIO3 interface from your KPA3 Option kit. It will
replace the jumper block in any case. You can install it only, then finish
up with  your tests and calibrations before going back to finish the KPA3
installation. 

Ron AC7AC

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of OE5CSP-Chris
Sent: Friday, June 27, 2008 4:08 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Power Amplifier Jumper Block



I almost finished my K3 tonight, but now there´s a problem. The assembly
manual on page 54 says, that the Power Amplifier Jumper Block is already
installed.Unfortunately there is no jumper installed in my K3 and I can´t
find it anywhere. I´d like to install the KPA 100 tomorrow, but I can´t go
on without doing the tests and calibrations(page 57) Did I miss anything or
is this jumper not required any more?


vy73 Chris-OE5CSP,K3 #1073
-- 
View this message in context:
http://www.nabble.com/Power-Amplifier-Jumper-Block-tp18165421p18165421.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com