[Elecraft] Power Amplifier Jumper Block

[Bud Semon N7CW]

Chris,

I just built s/n 1041 and it had the jumper block installed from the
factory.  It might still be early enough to call the factory and have them
send it tonight.

GL & 73, Bud N7CW

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of OE5CSP-Chris
Sent: Friday, June 27, 2008 4:08 PM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Power Amplifier Jumper Block


I almost finished my K3 tonight, but now there´s a problem. The assembly
manual on page 54 says, that the Power Amplifier Jumper Block is already
installed.Unfortunately there is no jumper installed in my K3 and I can´t
find it anywhere.
I´d like to install the KPA 100 tomorrow, but I can´t go on without doing
the tests and calibrations(page 57) Did I miss anything or is this jumper
not required any more?


vy73 Chris-OE5CSP,K3 #1073
-- 
View this message in context:
http://www.nabble.com/Power-Amplifier-Jumper-Block-tp18165421p18165421.html
Sent from the Elecraft mailing list archive at Nabble.com.

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com