[Elecraft] K3 Transverter Control Cable

[Don Wilhelm]

Ian,

Based on information I received from Wayne, I do believe that K3 ACC pin 
7 is now dedicated to TX INH.  There were complication in sharing it.  
If the change is not in the firmware version you are using, it will be 
with a forthcoming update.  In other words, it cannot be used for XVTR 
ON.  The +12 volt output from the back of the K3 should do nicely even 
though it means "Y"ing out one of the cable wires.

73,
Don W3FPR

Ian J Maude wrote:
> Bud Governale, W3LL wrote:
>> I'd like to make up a K3 Transverter control cable.
>>
>> Which pins of the Elecraft Transverter J6 DB-9 connector are 
>> connected to which pins of the K3 AUX I/O?
>>   
> XV DB9      K3 DB15
>
> Pin                    Pin
>
> 1 ground            5
> 6 auxbus            2
> 8 XVTR ON     7
> 9 PTT               10
>
> I hope that makes sense :)
>
> 73 Ian
>
>