[Elecraft] WTB: KSB2 SSB Adapter

[Dave White]

Hi Gary:

Thanks for the information, but I already those parts from previous builds 
of K2 equipment (and ordering K2 spare parts over the years), so the SSB 
will be about all I need.  I also have a very well stocked selection of 
electronic parts to draw from.

Regards

Dave

----- Original Message ----- 
From: "Gary Hvizdak" <garyhvizdak at cfl.rr.com>
To: <dwds at trinustech.com>
Cc: <elecraft at mailman.qth.net>; <support at unpcbs.com>
Sent: Friday, June 13, 2008 8:26 PM
Subject: RE: [Elecraft] WTB: KSB2 SSB Adapter


> At 2117 EDT on Fri Jun 13 2008 Dave White (VE6DRW) wrote ...
>
> I'm looking to purchase a KSB2 SSB adapter for the K2.  If you have one 
> you
> don't need, please let me know offline.
>
> --
>
> Hi Dave,
>
>    If you purchase a used KSB2, it won't come with all of the parts
> required to install it in your K2.  This is because an un-built KSB2 kit
> includes about a dozen parts which must be added to your K2:
>
> o   RF-J9, J10, J11
> o   FP-C4..C8, P1, Q3, R13, RP3
> o   3/8" Aluminum standoff
> o   Miscellaneous hardware
>
>    Thus if you purchase a used KSB2, the above parts will already be
> installed in the "sellers" radio.
>
> --- - - - ---
>
>    You can get the necessary parts from Elecraft by ordering each of them
> individually, or you can get a single kit containing all of them by
> purchasing the Rework Eliminator(TM) KSB2 Duplicate K2 PCB Parts kit.  To
> learn more about this kit, see the "What Else Do I Need?" and "Product
> Specifications" pages on the http://www.unpcbs.com/ website.
>
>    While you are there, also check out the Rework Eliminator(TM) K2
> Internal Mic Adaptor (IMA), which is described in detail on the FAQ page.
> The IMA makes it really easy to configure the K2 for seven different
> pin-outs which support more than 50 microphones!  The IMA also offers 
> jumper
> selection of the commonly required external bias resistances, and then 
> some.
> FYI, without the IMA your stock K2 doesn't have a "graceful" way to 
> provide
> (or to subsequently alter) external microphone bias resistance.
>
> 73,
> Gary  KI4GGX
> unpcbs.com webmaster
>
>