[Elecraft] KAT3 Auto Tuner issue

[Mike Fatchett W0MU]

I installed the KPA unit and now it seems to be working.........  Maybe it
was a power up issue.

Thanks for all the suggestions.

Mike W0MU

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Mike Fatchett W0MU
Sent: Thursday, June 12, 2008 4:21 PM
To: k3support at elecraft.com
Cc: elecraft at mailman.qth.net
Subject: [Elecraft] KAT3 Auto Tuner issue

I have my kit built but it does not seem to see the KAT3.  I have tried the
byp and auto setting in config.  When I push the ATU button is says not
installed.

I can hear relays switch in and out when I cycle through the test settings
in config.

I rechecked and the board appears to be plugged into the connector properly.
I am not sure how one could remove it easily without taking the back cover
off.

I have not updated the firmware and was about to install the 100w KPA unit.

Any suggestions?

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com