[Elecraft] KAT3 Auto Tuner issue

[BigAlT]

Possibly a stupid question, but have you enabled the KAT3 by turning power
off and back on after setting ATU to byp in config mode ?.
 Al WB6HPF

Mike Fatchett W0MU wrote:
> 
> I have my kit built but it does not seem to see the KAT3.  I have tried
> the
> byp and auto setting in config.  When I push the ATU button is says not
> installed.
> 
> I can hear relays switch in and out when I cycle through the test settings
> in config.
> 
> I rechecked and the board appears to be plugged into the connector
> properly.
> I am not sure how one could remove it easily without taking the back cover
> off.
> 
> I have not updated the firmware and was about to install the 100w KPA
> unit.
> 
> Any suggestions?
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://www.nabble.com/KAT3-Auto-Tuner-issue-tp17810978p17812113.html
Sent from the Elecraft mailing list archive at Nabble.com.