[Elecraft] K3: ERR PL1

[Joe Word]

Ken,

Did the CONFIG:VCO MD procedure, and now I do not see the error
messaage. So it looks like that fixed the problem.

Joe  N9VX

On 6/12/08, Ken K3IU <kenk3iu at cox.net> wrote:
> Joe:
> I would suggest that you redo the CONFIG:VCO MD procedure (pg 46 of the
> Owner's Manual).
> 73,
> Ken K3IU
>
> Joe Word wrote:
> After upgrading to 2.02 firmware I get the error message "ERR PL1"
when I go
> to 12 meters in SSB mode. The message stays on the screen
for a few
> seconds.

Anybody else see this?


Joe
> N9VX
_______________________________________________
Elecraft
> mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to
> post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft

Help:
> http://mailman.qth.net/subscribers.htm
Elecraft web page:
> http://www.elecraft.com


>