[Elecraft] K3 CW-in-SSB mode: force CW VOX?

[G4ILO]

GM3SEK wrote:
> 
> At present, selecting MODE=CW will cause the K3's transmitted signal to 
> jump frequency. To allow the QSO to continue without anyone needing to 
> re-tune, auto-CW (when enabled) should shift the VFO and display 
> frequency by the K3's sidetone offset, whenever the mode is changed 
> between SSB and CW. This is normal behavior in transceivers that fully 
> support auto-CW.
> 
> The requested change would not affect anyone who has not selected 
> auto-CW.
> 
Personally I would find this a very nice improvement even though I don't use
the auto-CW feature. I often start tuning around in SSB or data mode, and
finish up in the CW portion. As soon as I switch to CW mode I lose the
signal and have to hunt for it again. Perhaps achieving this would not be as
simple as it seems if the sideband used for CW is not the same as is being
used for data or SSB. But it would be nice to eliminate that annoyance.

-----
Julian, G4ILO  K3 s/n: 222 K2 s/n: 392
G4ILO's Shack: www.g4ilo.com
Zerobeat Ham Forums: www.zerobeat.net/smf
-- 
View this message in context: http://www.nabble.com/Re%3A-K3-CW-in-SSB-mode%3A-force-CW-VOX--tp17736705p17750402.html
Sent from the Elecraft mailing list archive at Nabble.com.