[Elecraft] [K3] NB indicator blinking

[Bob Cunnings]

Ah, the errata! I suppose it's the "blanking level" component of the
NB setting  which is "too high", which makes sense. Thanks,

Bob NW8L

On Sun, Jun 8, 2008 at 9:56 PM, Gary Hvizdak <garyhvizdak at cfl.rr.com> wrote:
> On Sun Jun 8 2008 at 2313 EDT Bob Cunnings (NW8L) wrote ...
>
> I've observed the NB icon blinking sometimes, only when the hardware
> blanker is being used. What does that mean?  I can't find any mention
> of this in the manual or in the more recent firmware release notes on
> the website.
>
> --
>
> Hi Bob,
>
> Per the rev. C1-4, K3 Owner's manual errata dated May 5, 2008 ...
>
> =========================================================================
> Page 24, bottom of left column, add:
>
> The NB icon will flash on/off if the I.F. blanker setting is too high for
> the present signal conditions.  If this happens, use a lower setting.
> =========================================================================
>
> 73,
> Gary  KI4GGX
>
>