[Elecraft] [K3] NB indicator blinking

[Gary Hvizdak]

On Sun Jun 8 2008 at 2313 EDT Bob Cunnings (NW8L) wrote ...

I've observed the NB icon blinking sometimes, only when the hardware
blanker is being used. What does that mean?  I can't find any mention
of this in the manual or in the more recent firmware release notes on
the website.

--

Hi Bob,

Per the rev. C1-4, K3 Owner's manual errata dated May 5, 2008 ...

=========================================================================
Page 24, bottom of left column, add:

The NB icon will flash on/off if the I.F. blanker setting is too high for 
the present signal conditions.  If this happens, use a lower setting.
=========================================================================

73,
Gary  KI4GGX