[Elecraft] K3: cw/vox/PTT ver 2.02 - bug

[Alexandr Kobranov]

Mike,
you are right...
When you have SSB + CW active (menu:CW WGHT press "1") there is now no 
conncetion between PTT/VOX mode for CW and CW sending in SSB mode.
(as it was in previous versions as I remember)
My previous messages concerning this was based on previous experience 
and only very short test with 2.02. Sorry.

It is surely bug in this beta version as NO CW QSK DELAY is applied, 
only RF based on Key is emitted.

The correct function is to use CW VOX/QSK setting incl. VOX CW DELAY 
which is now ignored.

To avoid CW RF ins SSB or (CW keying without QSK delay) set SSB-CW 
until influence of CW PTT/VOX/QSK setting will be back. Simply do not 
use Auto-CW in beta 2.02 or go back with F/W.

73!
L. -dst-


Mike Harris napsal(a):
> Hi,
> 
> Unless I'm misunderstanding something it works here.
> 
> SSB - PTT mode, press paddle whilst in RX results in CW with RF output. 
> Interestingly this happens even if true CW mode is not set to VOX.
> 
> Is this somehow broken in v2.02?  I haven't bothered to load it yet 
> because it doesn't offer me anything I currently need and I will let the 
> army of beta testers thrash it a bit.
> 
> Regards,
> 
> Mike VP8NO
> ----- Original Message ----- 
> From: "Ken Kopp" <k0pp at rfwave.net>
> To: <elecraft at mailman.qth.net>
> Sent: Saturday, June 07, 2008 10:38 PM
> Subject: [Elecraft] cw/vox/PTT w/ ver 1.96/1.73
> 
> 
> | Same here ... no CW TX if in SSB / PTT mode.  I use a foot
> | switch for PTT on SSB and VOX on CW.
> |
> | 73! Ken Kopp - K0PP
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>