[Elecraft] rtty and MK2R+ K-3

[Bill NY9H]

my  "lin out"  is set to  nor 025  and the
MK2r  "recording/ digital"   controls on the bottom right front panel 
are set about 12 high....
and all my apps have great audio input....


bill


At 08:32 PM 7/19/2008, Lyle Johnson wrote:
>>Is there a "trick" to shut off headphone audio and take it off the back.
>
>Audio is simultaneously available at front and rear headphone jacks, 
>and at the LINE OUT jack. Nothing special need be done.
>
>CONFIG:LIN OUT and sets the LINE OUT level (nor 10, for 
>example).  You can safely insert headphones into the LINE OUT jack 
>and verify there is audio coming out.  It will probably be low in 
>level, but present.  To keep distortion to a minimum, use a level of 
>10 or less when feeding the sound card input.
>
>Remember LINE OUT on the K3 is receiver audio from the K3 to the PC 
>and should go to the LINE IN connector on the PC soundcard.  LINE IN 
>is transmit audio to the K3 and should come from LINE OUT on the PC.
>
>If there is no audio at the K3's LINE OUT connector, even with the 
>level set quite high (50, for example), email k3support.  If there 
>is audio, then the problem is not in the K3.
>
>73,
>
>Lyle KK7P
>
>_______________________________________________
>Elecraft mailing list
>Post to: Elecraft at mailman.qth.net
>You must be a subscriber to post to the list.
>Subscriber Info (Addr. Change, sub, unsub etc.):
>http://mailman.qth.net/mailman/listinfo/elecraft
>
>Help: http://mailman.qth.net/subscribers.htm
>Elecraft web page: http://www.elecraft.com