[Elecraft] K3 kit problem

[Chad WE9V]

According to the manual:
MISO line stuck low (asserted)

* De-install option modules one at a time.
If no failing option module can be found,
there may be a problem on the RF board.

Chad WE9V

On Sat, Jul 12, 2008 at 2:19 PM, Dave Hachadorian <K6LL at arrl.net> wrote:
> Just finished building K3 sn 1176. When I went to do the reference
> oscillator calibration by zero-beating with WWV, I found that the receiver
> is deaf. Even with a large antenna connected, there is no increase in
> background noise, and no signals can be heard.
>
> When I turned the K3 off and then on again, it came up with ERR IO1. Scary
> stuff. Any suggestions?
>
> Thanks.
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>