[Elecraft] Band decoder and Tx Inhibit

[G3SJJ]

Oh thanks for that Andy. I'll get it wired up in the morning with 
confidence then! I know that Dave N3RD (of Top Ten) and Sig N3RS are 
eagerly awaiting their K3s and will also be interested.

73 Chris G3SJJ



Andrew Faber wrote:
> Chris,
>  I have my K3 hooked up to a Top Ten Yaesu decoder, and it seems to 
> work fine.  You need to connect 5 wires: the four BCD outputs and 
> ground.  Once I figured out the pin numbering it was straightforward  
> (Pins on the ACC jack are numbered 1-5, 6-10, 11-15 from right to left 
> and top to bottom, looking at the radio from the back).
>  73, andy, ae6y
> ----- Original Message ----- From: "G3SJJ" <g3sjj at btinternet.com>
> To: "Elecraft" <elecraft at mailman.qth.net>
> Sent: Tuesday, January 29, 2008 11:46 AM
> Subject: [Elecraft] Band decoder and Tx Inhibit
>
>
>> I wondered if any has connected up a TT Band Decoder to the ACC 
>> socket yet. I am just about to make up a suitable cable. Also theer 
>> was some discussion somewhile back about TX Inhibit for connecting to 
>> amps. Anyone done this. I see it needs an external +5v source.
>>
>> On my FT1kMP use the band data out socket f for my TT Decoder and 
>> pick up +12v from there, also amp relay switching. Would have been 
>> nice on the K3!
>>
>> Chris G3SJJ
>> _______________________________________________
>> Elecraft mailing list
>> Post to: Elecraft at mailman.qth.net
>> You must be a subscriber to post to the list.
>> Subscriber Info (Addr. Change, sub, unsub etc.):
>> http://mailman.qth.net/mailman/listinfo/elecraft
>> Help: http://mailman.qth.net/subscribers.htm
>> Elecraft web page: http://www.elecraft.com
>>
>
>
>