[Elecraft] Band decoder and Tx Inhibit

[Andrew Faber]

Chris,
  I have my K3 hooked up to a Top Ten Yaesu decoder, and it seems to work 
fine.  You need to connect 5 wires: the four BCD outputs and ground.  Once I 
figured out the pin numbering it was straightforward  (Pins on the ACC jack 
are numbered 1-5, 6-10, 11-15 from right to left and top to bottom, looking 
at the radio from the back).
  73, andy, ae6y
----- Original Message ----- 
From: "G3SJJ" <g3sjj at btinternet.com>
To: "Elecraft" <elecraft at mailman.qth.net>
Sent: Tuesday, January 29, 2008 11:46 AM
Subject: [Elecraft] Band decoder and Tx Inhibit


>I wondered if any has connected up a TT Band Decoder to the ACC socket yet. 
>I am just about to make up a suitable cable. Also theer was some discussion 
>somewhile back about TX Inhibit for connecting to amps. Anyone done this. I 
>see it needs an external +5v source.
>
> On my FT1kMP use the band data out socket f for my TT Decoder and pick up 
> +12v from there, also amp relay switching. Would have been nice on the K3!
>
> Chris G3SJJ
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>