[Elecraft] K1 trouble shooting question

[DW Holtman]

Hello,

Found the problem, as I strongly suspected, it was a mistake on my part. On 
page 42 it says to install a "100 uH choke at RFC2 and RFC5". I did not read 
the complete sentence and only installed the choke at RFC2.

Thanks for the help.

Best,
DW Holtnan
WB7SSN

----- Original Message ----- 
From: "DW Holtman" <tubestuff at comcast.net>
To: <elecraft at mailman.qth.net>
Sent: Wednesday, January 16, 2008 8:22 AM
Subject: [Elecraft] K1 trouble shooting question


> Hello,
>
> While waiting on my K3, I decided to order and put together a K1. The 
> whole procedure went great. The receiver worked great and the alignment 
> went smooth. After I installed the transmitter parts, there is no receive. 
> First I'm going to check for wrong parts, cold solder joint etc.  Looking 
> at the schematic drawings, the receive signal path goes through D10, D11 
> and D12 which were all installed during the transmitter parts installation 
> section.
>
> Does anyone have any other suggestions/ideas?
>
> Best,
> DW Holtman
> WB7SSN
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com