[Elecraft] K1 trouble shooting question

[DW Holtman]

Hello,

While waiting on my K3, I decided to order and put together a K1. The whole 
procedure went great. The receiver worked great and the alignment went 
smooth. After I installed the transmitter parts, there is no receive. First 
I'm going to check for wrong parts, cold solder joint etc.  Looking at the 
schematic drawings, the receive signal path goes through D10, D11  and D12 
which were all installed during the transmitter parts installation section.

Does anyone have any other suggestions/ideas?

Best,
DW Holtman
WB7SSN