[Elecraft] New DSP Firmware won't Load

[Don Wines]

Thanks Guys,

I must have missed that post!

Don
----- Original Message ----- 
From: "Dick Dievendorff" <dieven at comcast.net>
To: "'Don Wines'" <dwines at suddenlink.net>; <elecraft at mailman.qth.net>
Sent: Saturday, January 12, 2008 12:46 PM
Subject: RE: [Elecraft] New DSP Firmware won't Load


> Please update your USB to Serial Adapter driver.  There is a link to the
> Prolific web site in the Troubleshooting section of K3 Utility Help.
>
> 73 de Dick, K6KR
>
>
>
>
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wines
> Sent: Saturday, January 12, 2008 10:32 AM
> To: elecraft at mailman.qth.net
> Subject: [Elecraft] New DSP Firmware won't Load
>
> I downloaded the new K3 utility this morning so I could upgrade the K3
> firmware.
>
> The MCU V1.58 loads OK but the DSP V1.48 won't load. The K3 VFO B area 
> tells
>
> me "NEW K3UTIL SOFTWARE REQUIRED * * * *".
>
> I have reloaded the K3 utility (V1.1.1.7) but the DSP still won't load. It
> takes about 10 minutes for the attempt after which the K3 displays "E
> 000202" in VFO A and "ERR DSE" in VFO B. The manual tells me to reload the
> DSP firmware which is what I have been trying to do.
>
> I am using the Elecraft Serial/USB adapter cable.
>
> I have also tried the "Cold Boot" method to no avail.
>
> Is there any way to load older (working) versions of the firmware?
>
> Don Wines
> K5DW
> K3 #123
>
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
>