[Elecraft] New DSP Firmware won't Load

[Dick Dievendorff]

Please update your USB to Serial Adapter driver.  There is a link to the
Prolific web site in the Troubleshooting section of K3 Utility Help.

73 de Dick, K6KR




-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Don Wines
Sent: Saturday, January 12, 2008 10:32 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] New DSP Firmware won't Load

I downloaded the new K3 utility this morning so I could upgrade the K3 
firmware.

The MCU V1.58 loads OK but the DSP V1.48 won't load. The K3 VFO B area tells

me "NEW K3UTIL SOFTWARE REQUIRED * * * *".

I have reloaded the K3 utility (V1.1.1.7) but the DSP still won't load. It 
takes about 10 minutes for the attempt after which the K3 displays "E 
000202" in VFO A and "ERR DSE" in VFO B. The manual tells me to reload the 
DSP firmware which is what I have been trying to do.

I am using the Elecraft Serial/USB adapter cable.

I have also tried the "Cold Boot" method to no avail.

Is there any way to load older (working) versions of the firmware?

Don Wines
K5DW
K3 #123 


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com