[Elecraft] K3 Operating Tip: How to do RIT (sortof) with the "BIG" knob

[Greg]

For those who would like to use the large VFO A knob as if it were RIT,
there's
a setup just for you.

Once you have your base frequency (or RUN frequency in a contest) TAP A>B to
send the VFO A frequency to VFO B.  Then place the K3 into SPLIT mode.  Your
TX frequency will not change, but now you can tune your RX frequency with
the
VFO A knob to tune in those stations calling who are slightly off frequency.

In the CONFIG menu there's also a B>A function that you can assign to one
of the programable buttons.  This feature allows you to pick up your TX
frequency from VFO B to match your RX frequency on VFO A.