[Elecraft] Re: K3 NB indicator flasjing

[Stan Rife]

	I thought these kinds of questions were supposed to be posted to the
K3 support email list. 


Stan Rife
W5EWA
Houston, TX
K2 S/N 4216


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Eric Swartz - WA6HHQ,
Elecraft
Sent: Thursday, January 03, 2008 11:51 AM
To: David Ferrington, M0XDF
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] Re: K3 NB indicator flasjing


I believe this indicates that you have set the H/W NB threshold or width 
to too high of a value for your current noise or signal levels, which 
has the noise blanker activated a majority of the time. This will 
usually cause an unacceptable amount of intermodulation from adjacent 
signals.

Reduce the threshold or width setting to eliminate the flashing.

73, Eric  WA6HHQ
---
David Ferrington, M0XDF wrote:
> You know, this thread is all well and good, but no-one has yet 
> answered the original question :)
>
> Which is:
>
>   
>>> I might have missed this in the manual, but when I change the NB IF 
>>> width value, I can get to a point where the NB flashes - what does 
>>> this indicate?
>>>       
>
>   
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com