[Elecraft] Re: K3 NB indicator flasjing

[Eric Swartz - WA6HHQ, Elecraft]

I believe this indicates that you have set the H/W NB threshold or width 
to too high of a value for your current noise or signal levels, which 
has the noise blanker activated a majority of the time. This will 
usually cause an unacceptable amount of intermodulation from adjacent 
signals.

Reduce the threshold or width setting to eliminate the flashing.

73, Eric  WA6HHQ
---
David Ferrington, M0XDF wrote:
> You know, this thread is all well and good, but no-one has yet answered the
> original question :)
>
> Which is:
>
>   
>>> I might have missed this in the manual, but when I change the NB IF width
>>> value, I can get to a point where the NB flashes - what does this indicate?
>>>       
>
>