[Elecraft] K2 Control Board - Build Question - R18/R19 jumpers

[John Hoaglun]

Hello Builders,

I am working through the steps for the K2 control board. I am at the 
point where I am getting ready to install R18 and R19 on the bottom of 
the Control Board. I am not 100% clear on "Install short wire jumpers at 
R18 and R19..... on the top side of the board."

I realize that these pins are shared with J1 and J2.

1. Am I supposed to have short wires in the each of the pins but not 
connected to anything else?
2. Am I supposed to short/jump J1/1 to J2/1.... J1/2 to J2/2
3. Am I supposed to short/jump J1/1 to J1/2.... J2/1 to J2/2
4. Something else completely different?

Does anyone have any pictures and/or can you explain this to me?

Thanks, JH

-- 

John Hoaglun
NG0R - EN25
http://www.hoaglun.com