[Elecraft] K3 Error question

[David Ferrington, M0XDF]

Rich, when you get a resolution, please mail me it, so I can go and update
the Wiki ( 
<http://www.zerobeat.net/mediawiki/index.php/Firmware_Error_codes#ERR_PL1.2F
2>) with the resolution.

Sorry, I don't have any suggestions other than the troubleshooting shown in
the owners manual and the Wiki page.

> Think different, Macintosh.
Yep, have done for 23 years :)

On 10/2/08 03:57, "Greg" <ab7r at cablespeed.com> sent:

> Rich,
> 
> Just found your orig email.
> 
> If you want you can call me up till 9pm PST this evening at 360-320-3436.
> Or tomorrow but I will probably be in and out.
> 
> 73
> Greg
> AB7R
> 
> 
> -----Original Message-----
> From: elecraft-bounces at mailman.qth.net
> [mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Rich Lim
> Sent: Saturday, February 09, 2008 1:35 PM
> To: Elecraft
> Subject: [Elecraft] K3 Error question
> 
> 
> Hi guys, I just got around to building my K3, awesome
> kit!
> 
> Anyhow, I was wondering if someone can help me out a
> little bit until I can talk to customer support on
> Monday.
> 
> While doing the initial synthesizer calibration I keep
> getting an error message. I get "Error VCO" and the
> error code is "00003". When I turn the rid on I get
> the "Error PL1" message.  I did check jumpers and the
> crystal as suggested and they are correct. Any ideas?
> 
> Rich
> KQ9L
> 
> ___________________________
> Think different, Macintosh.

-- 
It is unwise to be too sure of one's own wisdom. It is healthy to be
reminded that the strongest might weaken and the wisest might err.
-Mohandas K. Gandhi (1869-1948)