[Elecraft] K3 Error question

[Greg]

Rich,

Just found your orig email.

If you want you can call me up till 9pm PST this evening at 360-320-3436.
Or tomorrow but I will probably be in and out.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Rich Lim
Sent: Saturday, February 09, 2008 1:35 PM
To: Elecraft
Subject: [Elecraft] K3 Error question


Hi guys, I just got around to building my K3, awesome
kit!

Anyhow, I was wondering if someone can help me out a
little bit until I can talk to customer support on
Monday.

While doing the initial synthesizer calibration I keep
getting an error message. I get "Error VCO" and the
error code is "00003". When I turn the rid on I get
the "Error PL1" message.  I did check jumpers and the
crystal as suggested and they are correct. Any ideas?

Rich
KQ9L

___________________________
Think different, Macintosh.
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com