[Elecraft] K3 SSB width control

[Greg]

This is on the issues list already.  The change will be to have 100 Hz steps
below 3.0 kHz and 200 Hz steps above that.

73
Greg
AB7R


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net]On Behalf Of Toby Deinhardt
Sent: Tuesday, February 05, 2008 2:11 PM
To: G4ILO
Cc: elecraft at mailman.qth.net
Subject: Re: [Elecraft] K3 SSB width control


> probably can't tell the difference between 2.6 and 2.7 so it's no real
> hardship to keep the DSP 100z narrower, but it's a bit of a niggle.

It's rather simple - above 2kHz the K3 uses 200Hz steps and below 2kHz
steps of 100Hz.

If you tune down from 2.7kHz: 2700, 2500, 2300, 2100, etc.

If you tune up from 1.8kHz: 1800, 1900, 2000, 2200, 2400, 2600, etc.

vy 73 de toby
_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com