[Elecraft] Re: OT: Removing Solder Through Plated Through Holes

[David Ferrington, M0XDF]

Well, if the board is clean and free of components, then you should be  
able to measure resistance 9or lack of it) between the pads on either  
side.

For double sided boards, this may not be a big problem, just make sure  
you solder whatever lead is going through the hole on both sides.
73 de M0XDF, K3 #174
-- 
Ok, so what's the speed of Dark?

On 30 Dec 2008, at 22:17, jimimaxi2 at comcast.net wrote:

> If I have done what you say I shouldn't , meaning take a hobbyist  
> drill to widen a solder-filled hole, how do I check if I have broken  
> the connection between top side and bottom side?
>
> Thanks for help,
>
>
> Jim Curione
>
> KC2ROF
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081230/ce2806ac/attachment.htm