[Elecraft] [ K2 KX1 K1 ] Advice sought on Elecraft radios

[Daniel Paul Perez]

I was wondering if I might get some insight, perspective and counsel on 
Elecraft CW QRP DX radios from the group.

About six years ago, I lived across the street from MIT Lincoln 
Laboratory and Hanscom AFB.  Space was limited so I built a NorCal 40A a 
purchased a Hi-Q-Antennas 380 Tune A Dipole NVIS for portable use inside 
or on a porch.  Subsequently I purchased an older non-dsp built K2 QRP 
#502.

To the point, I’m still not all that happy with the level of noise on 
the K2.  If I connect a miracle antenna or the hi-q-antennas between the 
NorCal 40A and Elecraft K2 the Norcal 40A is much less fatiguing to 
listen to and seems to “hear” a little better.  Additionally, a couple 
of hams from the local clubs CWA and PART helped me set up the 
HI-Q-Antenna 380 TAD in September at my new home and then we tried a $5 
home made 20M dipole between two trees oer a shed that was 
“significantly” louder on both the K2 and Norcal.  The NorCal 40A and K2 
are being switched back and forth in the same setting and environment. 
We had an MFJ antenna analyzer to test with as well – the 380 TAD tunes 
1:1 beautifully and is optimized for 40M and military frequencies.  It’s 
an impressive piece of engineering.  So here I am with an antenna(s) 
that cost more than the K2 radio, and satisfied with neither.  I’ve sent 
the K2 to Elecraft’s Gary Surrency twice who certifies its one of the 
ten best sounding and 10 best built radios he’s seen.  I’m using a 
Samlex power supply.  I purchased a Cobra Ultralite Sr. with a Balun 
Designs balun that I hope to have in the trees in the next few weeks 
when the tree guy gets out from under his ice storm damage workload. 
Maybe this wil be a game changer?

I’m thinking to go to a KX1, or K1 (build or purchase) or the Icom-703+ 
with 400 Inrad.  Would these be quieter radios more like the 40A?  I 
understand the 703+ and K2 are similar generation/concept designs.  Why 
is the Norcal 40A much quieter than the K2?  The radios are from the 
same pedigree and designer.  I thought about the basic K3 but I’m not 
sold on the K2.  Which receiver is better between the KX1, K1?  I like 
the concept of the KX1 as I‘m a functional quadriplegic in an electric 
wheelchair and smaller packages appeal to me.  However, I also have 
profound hearing loss and would need ipod amplified speakers on the KX1. 
  The K1 appeals as well, but will it be as fatiguing as the K2?  Would 
the 703+ be quieter than all of the above as well ?  How much better is 
the K1 or KX1 receiver than the 703+?  I also have spare 28A and 60A gel 
cell wheelchair batteries – could I power the KX1 or K1 with these?

My interest is QRP DX [CW] and in general lifelong learning about the 
world and environment.  I have been essentially off the air for 20+ 
years and used to be 25-30wpm.  My first rig was an Icom 735.

Thanks for your advice and patience.

Dan
AD1P
Chesapeake1787 at post.harvard.edu