[Elecraft] Automatic diversity configuration

[Guy, K2AV]

My problem is that once in diversity mode I can't seem to turn it off
(admittingly assuming it's a toggle).  What's the command sequence to turn
off diversity (other than power off and on)?

73, Guy


wayne burdick wrote:
> 
> Joachim wrote:
> 
>> I've just installed MCU 2.76 and find that the diversity auto config 
>> no longer works. Anyone else notice this?
> 
> Hi Joachim,
> 
> I just tested this and it appears to be working. What you may be 
> noticing is that in diversity mode (*long* hold of SUB), VFO B is no 
> longer linked to VFO A. In recent revisions, VFO A still controls both 
> synthesizers, but VFO B is left independent so it can be used for SPLIT 
> with diversity (i.e., as the transmit frequency).
> 
> You'll also notice that in diversity mode, the VFO A kHz decimal point 
> flashes as a reminder. If you link the VFOs (normal hold of SUB), the 
> VFO B kHz decimal point flashes. In fact you can still link VFO B to 
> VFO A if desired, even in diversity mode, but more likely you'll leave 
> VFO B free to use for split.
> 
> One other change in the most recent revision is that PRE and ATTN are 
> independent for the main and sub receivers. Use BSET to set up the sub 
> receiver's PRE and ATTN.
> 
> 73,
> Wayne
> N6KR
> 
> ---
> 
> http://www.elecraft.com
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 
> 

-- 
View this message in context: http://n2.nabble.com/Automatic-diversity-configuration-tp2018985p2090203.html
Sent from the Elecraft mailing list archive at Nabble.com.