[Elecraft] K3- NO Output Power

[Ned]

Some things to check...

- Check: Config TX INH needs to be set to "false"

- Be sure that you are not in the test mode (TX is blinking) -- Press and
Hold "Mode Up/test" to toggle

- Connect dummy load, and press & hold "XMIT/Tune" -- if this works, then
the hardware is probably OK.

- If in CW, Press "XMIT" and try to send. If that works, then

- Be sure that the VOX is selected to enable QSK -- Press and hold
"Band/Down" to toggle between VOX and PTT.. When selected, the VOX symbol
will appear in the display.

Good luck with your new K3...

73, Ned, W2NED
K3 sn: 1072


K5HTK wrote:
> 
> My newly assembled K3 has no power output. I have tried all the
> configuration "settings" that might affect output. I have checked all the
> assembly procedures to assure I did all correctly. ...
> K5HTK
> 
>  
> 
> 
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
> 

-- 
View this message in context: http://n2.nabble.com/K3--NO-Output-Power-tp2019252p2089432.html
Sent from the Elecraft mailing list archive at Nabble.com.