[Elecraft] [K3] Short TX burst when changing mode from Data to AM

[Joe Planisky]

Hi Kari,

Yes, this was just reported and discussed a few days ago :-) See the  
messages with the subject line "Transmit when switching from DATA to  
AM mode?" starting Dec. 25, 2008.  It has been reported to Elecraft.   
Until it's fixed, one possible work around is to reduce VOX Gain when  
not using VOX.

73
--
Joe KB8AP



On Dec 28, 2008, at 11:15 AM, Karza wrote:

> Hi,
>
> When I change mode of my K3 #310 from Data to AM
> using the "Mode <down>" -button, a short
> ( abt 1 second ) TX burst gets sent out.
> Burst power is roughly 1/5 of the requested
> output power.
>
> This happnens if VOX Gain is set to about 20 or
> higher and even when there are no mic-, data- or
> RS232-cables connected.
>
> I'm running MCU 2.76 with DSP 1.98
>
> Anyone else noticed this?
>
> 73's de Kari
> oh2gqc