[Elecraft] K3 and MixW audio input volume

[K2MK]

Also Peter, if you have the SUB turned on the Main receiver will be on the 
left channel and SUB will be on the right channel. You might want to check 
your audio level adjustments on your PC. Maybe the left and right levels are 
not the same. I use a CONFIG: LIN OUT setting of "nor 010" but you also have 
to consider the setting on your PC line-in. And check the back of the K3 to 
be sure the line out plug is actually plugged into the line out jack and not 
the headphone or speaker jack.

73,
Mike K2MK


RE: [Elecraft] K3 and MixW audio input volume
Greg
Sat, 27 Dec 2008 16:36:05 -0800

Peter,

If you are using the SUB and Main RX at the same time on the same antenna
you will see a 3 dB drop in signal.  Try increasing your Line Out setting to
about 10.

73
Greg
AB7R

  -----Original Message-----
  From: elecraft-boun... at mailman.qth.net
[mailto:elecraft-boun... at mailman.qth.net]on Behalf Of Peter ZL1PWD
  Sent: Saturday, December 27, 2008 4:26 PM
  To: elecraft at mailman.qth.net
  Subject: [Elecraft] K3 and MixW audio input volume


  Seasons greetings from ZL,

  I have just upgraded to the 2nd RX and DVR and now get very little signal
showing on the MixW waterfall. Not sure if there is a connection

  Using the latest FW and Menu item MIC SEL = LINE IN

  Config Item LIN OUT=3

  Any thoughts??

  TIA and 73

  Peter  ZL1PWD