[Elecraft] K-2 alignment and Test - Part 1 problem

[Larry Wright]

I have attempted to do the alignment and Test  part 1 on page 43 of the manual.    Controls were set as indicated in the manual.  When power turning on the K-2 with S1, there is nothing on the display.  It does not read "INFO 201" or  "7100c".  Neither will it read "Elecraft" for two seconds.   The display always remains blank.  It does pass the relay test when tapping the "Band+"  switch.  I also hear the relay click when the "PRE/ATTN" button is tapped.

Current drawn is about 125 ma from a 12.6 volt battery.  Any help will be appreciated.

Thanks.

Larry
n4qy at att.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081227/e329287f/attachment.htm