[Elecraft] Automated Transmit Gain Calibration at 5 W, 50W, err txf

[Dick Dievendorff]

Using the K3 Utility's Configuration tab, click "Configure Crystal Filters"
(maybe it's Edit Crystal Filters) and verify that the filters you have
chosen for Tx CW and Tx SSB are your 2.7 filter in slot 2. 

Is this the issue?

Dick, K6KR


-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of jeff kb2m
Sent: Saturday, December 27, 2008 8:55 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] Automated Transmit Gain Calibration at 5 W, 50W, err txf

I'm trying to run the Calibrate Transmitter Gain routinre in Utility ver 
1.1.12.22 on my K3 # 1516. And I'm getting this error...

Starting 5 Watt calibration.

Calibrating at 1.900 MHz

Unexpected response "DBERR TXF;" to "DB;". State 127

5 Watt calibration failed.

 I verified that I have my 2.7 filter in # 2 slot selected, and I tried it 
with ATU in auto and bypass. I'm also getting a ERR TXF error.  The dummy 
load I'm  using I verified that it is close to 1 to 1 . Any suggestions?

73 Jeff kb2m


_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com