[Elecraft] KIO2 connect to Ubuntu Linux

[Bob Nielsen]

The command you are probably looking for is 'setserial' and you may  
need to install the setserial package using synaptic or apt-get.  Try  
'man setserial' for syntax.  Most Linux programs which can  
communicate with the K2 use the hamlib library (install the  
libhamlib2 package).

Bob, N7XY

On Dec 25, 2008, at 10:40 AM, Arthur Gunn wrote:

> My memory of how I connected my K2 to this Ubuntu 8.10 computer has  
> faded over the last year. Although the Ubuntu version then was  
> 7.04, the computer was the same.
>
> I have been attempting to configure the com 1 serial port with the  
> root command:
>
> serial:/dev/ttyS0?baud=4800+stop=2+parity=none
>
> The reply is "file does not exist."
>
> I see file size for ttyS0 as 0 bytes. Could it be that I need to  
> create a special ttyS0 file? Since I do not remember that step  
> before, I am a bit lost here.
>
> Maybe there is a configuration program for com port config that  
> does not expect to write to a dial up modem!.
>
> Any guidance would be appreciated.
>
> Arthur
> VE9BP
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
> http://mailman.qth.net/mailman/listinfo/elecraft
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com