[Elecraft] K3 Subreceiver ANT selection doesn't work - always uses the AUX antenna

[Bruce McLaughlin]

In addition to using BSET, did you also check the configuration menu entry
for KRX3 to be sure it is set to ANT=BNC?  That, along with using BSET and
then the ANT switch to be sure it is using antenna number one, which I
assume is what you are using for your main transmit receive antenna, should
do the trick.

Bruce-W8FU

-----Original Message-----
From: elecraft-bounces at mailman.qth.net
[mailto:elecraft-bounces at mailman.qth.net] On Behalf Of Frank R. Oppedijk
Sent: Wednesday, December 24, 2008 9:19 AM
To: elecraft at mailman.qth.net
Subject: [Elecraft] K3 Subreceiver ANT selection doesn't work - always uses
the AUX antenna

Hi,

I've just installed my KRX3. All went okay. Although I do have a KAT3 
installed, I chose the subreceiver's alternative antenna to be the BNC one.

If I've understood correctly, pressing BSET followed by ANT allowes 
me to switch the subreceiver's input between the main receiver's 
antenna and the BNC antenna. But, irrespective of whether I've 
selected MAIN or AUX, the subreceiver always uses the AUX antenna.

Any clues as to what could be wrong?

73,

Frank PA4N



---
drs. ing. F.R. Oppedijk
Avista ICT Consultancy B.V.
Albert Schweitzerlaan 7
1277 BV  Huizen

tel: 035 - 523 09 83
fax: 035 - 523 09 84 

_______________________________________________
Elecraft mailing list
Post to: Elecraft at mailman.qth.net
You must be a subscriber to post to the list.
Subscriber Info (Addr. Change, sub, unsub etc.):
 http://mailman.qth.net/mailman/listinfo/elecraft    

Help: http://mailman.qth.net/subscribers.htm
Elecraft web page: http://www.elecraft.com