[Elecraft] 50 and 100 DSP positions

[WILLIS COOKE]

My K3 is #1025.  I think I am on version 2.67.  I do dot observe the audio reduction.  If I have a pop, it is high frequency because I do not hear it.  My hearing is such that I don't hear above about 2.7 kHz.  It is the same for both receivers.  It is the same pre-amp on and off.  The test was made at 7052 Khz.

Willis 'Cookie' Cooke 
K5EWJ


--- On Tue, 12/23/08, W8ZN at comcast.net <W8ZN at comcast.net> wrote:

> From: W8ZN at comcast.net <W8ZN at comcast.net>
> Subject: [Elecraft] 50 and 100 DSP positions
> To: Elecraft at mailman.qth.net
> Date: Tuesday, December 23, 2008, 9:24 AM
> Hi all,
> 
> On K3's #94 and #965, on cw when you narrow the DSP
> down past 150 to 100, there is a noticable pop in the
> speaker and the audio becomes quite muted. The S meter still
> shows the same strength. Both are running 2.73. I've
> tried moving the IF shift but still muted audio. You can
> hear it, but just way down.
> 
> Can anyone verify if their's acts the same way?
> 
> thanks!!
> 
> Terry
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft    
> 
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com