[Elecraft] Re: K3: Firmware Request

[wayne burdick]

Steve wrote:

> ...I need to set Proc=0 and Mic=0 just before transmitting in MT63, and
> after the transmission I need to reset Proc=10 and Mic=15 so I can
> immediately start talking on the radio.

Hi Steve,

The most recent releases of code include both mic gain (MG) and speech 
compression (CP) commands. Just load rev 2.73 (beta), go into K3 
Utility, and type "MG;" or "CP;" to see the present values.

Let me know if I can fulfill any more firmware requests tonight  :)

73,
Wayne
N6KR


---

http://www.elecraft.com