[Elecraft] No Speaker output

[S Sacco]

Carsten -

I am experiencing the same problem.  At this point, after confirming that
it's not the KAIO3 boards, Elecraft suspects a bad DSP board, and they're
sending me a replacement.   I'm hoping this resolves the problem.

Good luck & 73,
Steve NN4X



On Tue, Dec 9, 2008 at 5:34 AM, Carsten Steinhöfel <
carsten.steinhoefel at web.de> wrote:

>
> Hi there,
>
> I have a little problem with K3 #549. I do not get AF out of the internal
> Speaker
> or rear-panel Speaker output. I am usually using headphones so only noticed
> it
> recently in Senegal when I wanted to have my YL listen to a sked with home.
>
> It doesn't seem to be a hardware problem because when I set SPKR+PH to yes
> in the
> menu I do get output. Only if it is set to no and I don't have headphones
> connected
> is there no output. I've tried setting SPKRS to 1 and 2 with no difference.
> Is
> there some other setting that I am missing that could be causing this
> behaviour?
>
> I've also tried upgrading to the latest firmware but that didn't make a
> difference
> either.
>
> I'd be grateful for any ideas.
>
> Thanks and regards,
>
> Carsten, DL1EFD
>
> _______________________________________________
> Elecraft mailing list
> Post to: Elecraft at mailman.qth.net
> You must be a subscriber to post to the list.
> Subscriber Info (Addr. Change, sub, unsub etc.):
>  http://mailman.qth.net/mailman/listinfo/elecraft
>
> Help: http://mailman.qth.net/subscribers.htm
> Elecraft web page: http://www.elecraft.com
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081209/cae10a02/attachment.htm