[Elecraft] K3 New owner 2B Checklist

[ni0c]

Gary, KA1J, wrote: 
"Any other suggestions regarding a heads up perhaps regarding 
specialty assembly/test equipment I will need to be ready for the k3 
100W kit? "

The most helpful tool for me was a nice tweezers
to pick up all those little lockwashers.  As far as
test equipment goes, a standard DMM is helpful. 
All the calibration and alignement is either done at 
the factory or performed by initiating pre-programmed
routines in the K3 itself.  I especially appreciate the
dial calibration procedure, using WWV as a reference
to get the reading within 1-2 Hz.  It's so easy, I check 
it from time to time.

Have fun!

73 de Chuck  NI0C
K3/100 s/1061
K2/10  s/n 5853
   

-------------- next part --------------
An HTML attachment was scrubbed...
URL: http://mailman.qth.net/pipermail/elecraft/attachments/20081202/2829a276/attachment.htm